Informational Only · Not Legal Advice · No Attorney-Client Relationship · Editorial Policy

An Insulin Pump Delivering an Incorrect Dose: When Might Punitive Damages Be Available?

Punitive damages in an insulin pump case are available only where the manufacturer knew its pump could misdose and sold or kept selling it anyway. Compensatory damages pay for the injury; punitive damages punish conduct, and almost every state requires clear and convincing evidence of malice, fraud, or conscious disregard of a known danger before a jury may award them. That standard turns the case into a documents case. The question is not whether the pump failed, but what the company's own complaint files, engineering reviews, and regulatory correspondence show it understood before the device reached the patient.

Table of Contents

Which pump failures are already documented

Recent federal actions describe exactly the kind of defect these claims are built on. The FDA's notice that Insulet removed certain Omnipod 5 pods explains that a small tear in internal tubing lets insulin leak inside the pod instead of reaching the wearer, causing under-delivery and high blood sugar. The agency issued an early alert on March 18, 2026 and classified the removal as Class I — its most serious category — on April 29, 2026. Medtronic's actions cover far more devices.

Its MiniMed 780G correction warned that a damaged, broken, or missing retainer ring can let the reservoir seat improperly, so the pump delivers too much or too little insulin; reporting on the FDA recall database puts the action at roughly 560,000 pumps, including 453,144 MiniMed 780G units. In February 2026 the company separately notified customers that Paradigm-series, 600-series, and BLE 700-series pumps — the 530G, 620G, 630G, 700G, and 740G — were affected by unintended over- and under-delivery, and the FDA classified those recalls Class II on February 13, 2026. Not every action is a removal. The FDA classified a Tandem Mobi recall on November 5, 2025 over a software malfunction that could interfere with insulin delivery and cause hyperglycemia, but that one was a correction requiring a user software update rather than a product pull.

Why the FDA clearance pathway decides whether you can sue at all

Before punitive damages matter, the claim has to survive federal preemption. Insulin pumps of this type are Class II devices regulated under 21 CFR 880.5730, product code QFG, and they reach the market through 510(k) clearance — a showing of substantial equivalence to an existing device — not through premarket approval. The Omnipod 5 ACE Pump cleared as K231826 on October 18, 2023; the Tandem Mobi cleared as K223213 on July 10, 2023. That distinction is the whole ballgame. In *Medtronic v.

Lohr* (1996) the Supreme Court held that state tort claims over 510(k)-cleared devices are not preempted. Twelve years later, in *Riegel v. Medtronic*, the Court held 8–1 that the Medical Device Amendments preempt design and labeling claims against premarket-approved devices. So a defect claim against a 510(k)-cleared insulin pump proceeds under ordinary state product liability law, including its punitive damages rules. The same injury caused by a PMA-approved implant would likely be barred outright. Check the clearance number for the specific model and software version before assuming either result.

What evidence supports a punitive claim

Punitive damages require a heightened mental state proven to a higher standard than the rest of the case. California Civil Code § 3294 requires oppression, fraud, or malice; Maryland requires actual knowledge of the defect plus deliberate disregard of the consequences. A survey of state damages rules by Faegre Drinker sets out how widely those formulations vary.

In practice, the evidence that moves a punitive claim comes out of discovery, not out of the recall notice: A recall by itself is weak punitive evidence. A company that finds a defect and promptly notifies the FDA is doing what the system asks. The claim gets strong when the record shows the company sat on what it knew.

  • Internal complaint and adverse-event logs showing the same failure mode reported repeatedly before the recall
  • Engineering or design-review records identifying the tubing tear, retainer ring, or software fault and the decision not to change it
  • Sales and distribution data showing shipment of affected lots after the defect was known
  • The timing gap between first internal knowledge and the customer notification date
  • Evidence that a cheaper or unavailable fix was rejected on cost grounds

The ceiling on any award

Even a well-supported punitive verdict is policed constitutionally. In *State Farm v. Campbell*, decided April 7, 2003, the Supreme Court voided a $145 million punitive award set against $2.6 million in compensatory damages. The Court called the reprehensibility of the conduct the most important guidepost and said awards should rarely exceed single-digit multipliers of compensatory damages. State caps narrow the range further, and they do not move in the same direction.

Georgia's $250,000 punitive cap expressly excludes product liability cases, leaving those uncapped. Connecticut limits a product punitive award to twice compensatory damages. Colorado's product cap ran about $729,790 for 2024, doubling to roughly $1,459,600 on clear and convincing justification. The practical consequence is that compensatory damages still drive case value. A severe hyperglycemic injury with large medical bills and lost earnings raises the punitive ceiling along with everything else; a scare with no lasting harm leaves little for a multiplier to work on.

One state where there is no punitive route

New Jersey is the sharpest limitation to know about, because so many device companies are sued there. Its Products Liability Act, N.J.S.A. 2A:58C-5(c), bars punitive damages for FDA-regulated products except on proof of fraud on the FDA — and as the Drug & Device Law blog documents, New Jersey courts have held that exception itself preempted under *Buckman Co. v.

Plaintiffs' Legal Committee*. The result is a closed door: the statute permits punitive damages only through a theory federal law does not allow a state jury to hear. Other states with FDA-compliance defenses, including Michigan and Ohio, apply their own versions, some rebuttable and some not. This makes venue a threshold decision rather than a detail. Where a plaintiff lives, where the pump was prescribed and used, and where the manufacturer is incorporated can each change whether punitive damages exist as a remedy — and that analysis belongs at the start of a case, before a filing locks the choice of law in.

Steps that preserve the claim

The statute of limitations on a product injury claim runs from one to six years depending on the state, and some states date it from discovery of the cause rather than the injury. A recall announcement is often what starts that clock running in a discovery-rule state.

  • Keep the pump, pod, reservoir, and packaging, unwashed and unreturned; a manufacturer replacement request will ask for the device back, and the physical part is the defect evidence
  • Photograph the lot or serial number and record the software version before anything is sent anywhere
  • Download and save the pump's own delivery and alarm logs, plus CGM data for the same hours
  • Match the lot number against the specific FDA recall record for that model, not a general news summary
  • Get the hospital records for the episode itself, which document the blood glucose readings a defect claim is built around

Frequently Asked Questions

Does an FDA recall prove the manufacturer was reckless?

No. A recall establishes that a defect exists and often when the company told regulators about it. Reckless disregard has to be proven from internal records showing what the company knew before it shipped the affected devices.

Can I pursue punitive damages if my pump was corrected by a software update rather than recalled?

Possibly. The FDA classified the Tandem Mobi action of November 5, 2025 as a correction requiring a user software update, not a removal, and a correction still documents a delivery-interfering malfunction. The analysis turns on the company's pre-release knowledge of the fault.

Who pays punitive damages — the manufacturer or an insurer?

Many liability policies exclude punitive damages, and several states bar insuring against them as a matter of public policy. That is one reason defendants fight the punitive count hardest even when it is a small share of the demand.


You Might Also Like

We use essential cookies to make this site work and remember your preferences. We do not use advertising or analytics cookies. Privacy Policy.